Link G5 ECU Nylon Backshell

FDM 3d printed backshell for the Link G5 Engine Management System.

This part saves time and a bit of cash when terminating the Link G5 ECU to your custom wiring harness, while also producing a very clean end result.

Easy to repair or make changes at the ECU connector thanks to the bolt-together design.

Plenty of room to fully populate the ECU and hide all your splices, resistors, etc.

ECU connectors are not included.

This part is used primarily for ECU's installed inside the vehicle cabin or a somewhat protected space. While it does provide some protection from fluid splashes and sand for example; it is not waterproof.

Made out of 20% Carbon Fiber filled PA6 (more commonly known as "nylon").

If you would like your company logo embossed into the part, or need a back shell for a different ECU get in touch with me via email x@millerspec.tech

"RIGHT OR LEFT EXIT IS DETERMINED WHILE THE ECU CONNECTORS ARE FACING YOU"